EMDI/4/hwEmdiBierOutRtpSerOverThreshold_active

Message

EMDI/4/hwEmdiBierOutRtpSerOverThreshold_active: The outbound packet disorder rate of the channel exceeds the threshold. (ChannelSourceAddress=[hwEmdiChannelSourceAddress], ChannelGroupAddress=[hwEmdiChannelGroupAddress], VpnLabel=[hwEmdiVpnLabel], BfirId=[hwEmdiBfirId], SubDomain=[hwEmdiSubDomain], Bsl=[hwEmdiBsl], SI=[hwEmdiSi], RtpSerThreshold=[hwEmdiRtpSerThreshold], RtpSer=[hwEmdiRtpSerValue], Slot=[hwEmdiChannelSlot], Interface=[hwEmdiChannelInterface], Token=[hwEmdiToken])

This log is supported only on NetEngine 8000 F1A.

Description

The outbound RTP-SER of the channel exceeds the threshold.

Parameters

Parameter Name	Parameter Meaning
hwEmdiChannelSourceAddress	Channel source address.
hwEmdiChannelGroupAddress	Channel group address.
hwEmdiVpnLabel	VPN label.
hwEmdiBfirId	Bit forwarding ingress router id.
hwEmdiSubDomain	Sub domain.
hwEmdiBsl	BitString length.
hwEmdiSi	Set identifier.
hwEmdiRtpSerThreshold	Current packet disorder rate threshold of a channel.
hwEmdiRtpSerValue	Current packet disorder rate value.
hwEmdiChannelSlot	Slot ID.
hwEmdiChannelInterface	Interface Name.
hwEmdiToken	Multicast leaf token.

Possible Causes

The disordered rate of outbound packets in bier channel was too large.

Procedure

1.According to the bier eMDI statistical information to confirm the fault equipment. (bier eMDI does not differentiate upstream and downstream traffic. Bier eMDI needs to globally analyze fault points on the entire network based on information about each detection point.)

2.Replace optical modules or optical fibers of faulty equipment. Then check whether the trap is cleared.

If the trap is cleared, go to Step 4.
If the trap persists, go to Step 3.

3.Collect trap, log, and configuration information, and then contact technical support personnel.

4.End.