DEVM/2/hwEntityCheckFail_active-69636

Message

DEVM/2/hwEntityCheckFail_active: Physical entity is detected failed. (BaseTrapSeverity=[BaseTrapSeverity], BaseTrapProbableCause=69636, BaseTrapEventType=[BaseTrapEventType], EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalContainedIn=[EntPhysicalContainedIn], EntPhysicalName=[EntPhysicalName], RelativeResource=[RelativeResource], ReasonDescription=MPU <slotid>%s is failed, the chassis ID conflict.)

In VS mode, this log is supported only by the admin VS.

Description

Physical entity is detected failed.

Parameters

Parameter Name	Parameter Meaning
BaseTrapSeverity	indicates the severity level of the trap reported to the NMS.
BaseTrapProbableCause	Indicates the possible cause of the trap.
BaseTrapEventType	Indicates the trap type.
EntityPhysicalIndex	Physical index. The physical index varies with the chassis ID.
EntPhysicalContainedIn	Indicates the parent index.
EntPhysicalName	Indicates the name of the entity such as a chassis.
RelativeResource	Indicates the name of the part related to the trap.
ReasonDescription	Indicates the description of the possible cause.

Possible Causes

MPU slotid%s is failed, the chassis ID conflict.

Procedure

1. Check alarm information and locate the chassis with a conflicting ID.

2. Run the set [ chassis chassis ] chassis-id chassis-id command to set the ID of the chassis. Check whether the trap is cleared.

If so, go to Step 4.
If not, go to Step 3.

3. Collect trap information, log information, and configuration information, and then contact technical support personnel.

4. End.