DEVM/1/hwEntityInvalid_active-67590

Message

DEVM/1/hwEntityInvalid_active: Physical entity failed. (BaseTrapSeverity=[BaseTrapSeverity], BaseTrapProbableCause=[67690], BaseTrapEventType=[BaseTrapEventType], EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalContainedIn=[EntContainedIn], EntPhysicalName=[EntPhysicalName], RelativeResource=[RelativeResource], ReasonDescription=The temperature sensor was faulty.)

In VS mode, this log is supported only by the admin VS.

Description

Physical entity failed.

Parameters

Parameter Name	Parameter Meaning
BaseTrapSeverity	To describe the level of trap.
ProbableCause	To describe the probable cause of trap.
BaseTrapEventType	To describe the type of trap.
EntityPhysicalIndex	The index of the physical entity.
EntContainedIn	The value of entPhysicalIndex for the physical entity.
EntPhysicalName	The textual name of the physical entity.
RelativeResource	This object may contain a key word to indicate the relative resource of an entity.
ReasonDescription	To describe the reason of trap in DisplayString style.

Possible Causes

The temperature sensor was faulty.

Procedure

1. Run the power on and the power off commands on the faulty board. After the board is registered, check whether the alarm is cleared.

If so, go to Step 2.
If not, go to Step 5.

2. Insert and remove the board. After the board is re-registered, check whether the alarm is cleared.

If so, go to Step 3.
If not, go to Step 5.

3. Replace the board and check whether the alarm is cleared.

If so, go to step 5.
If not, go to Step 4.

4. Collect trap, log, and configuration information, and contact technical support.

5. End.