DEVM/2/hwFlexEPhyNumberMismatch_active: The configured phy-number parameters did not match for the two connected FlexE physical interfaces.(hwPhysicalPortIfIndex=[hwPhysicalPortIfIndex], hwPhysicalPortName=[hwPhysicalPortName], hwPhysicalPortLocalPhyNumber=[hwPhysicalPortLocalPhyNumber], hwPhysicalPortRemotePhyNumber=[hwPhysicalPortRemotePhyNumber])
In VS mode, this log is supported only by the admin VS.
The configured phy-number parameters did not match for the two connected FlexE physical interfaces.
| Parameter Name | Parameter Meaning |
|---|---|
|
hwPhysicalPortIfIndex |
Index of physical port. |
|
hwPhysicalPortName |
Name of physical port. |
|
hwPhysicalPortLocalPhyNumber |
Local phy-number value. |
|
hwPhysicalPortRemotePhyNumber |
Remote phy-number value. |
The configured phy-number parameters did not match for the two connected FlexE physical interfaces.
1.Configure phy-number parameters of the two connected FlexE physical interfaces be the same. Then check whether the alarm is cleared.
2.Collect alarm information, log information and configuration information, and then contact technical support personnel.
3.End.