DEVM/4/hwIfMonitorOutputRateRising_active

Message

DEVM/4/hwIfMonitorOutputRateRising_active: Interface output flow bandwidth usage exceeded the trap threshold. (Interface=[IfIndex], BandWidthUsage=[hwIfMonitorOutputRatePercentage], TrapThreshold=[hwIfMonitorOutputRateThreshold], InterfaceName=[InterfaceName])

In VS mode, this log is supported only by the admin VS.

Description

The trap was generated when the percentage of the rate of sent traffic to the total bandwidth on an interface was greater than the threshold.

Parameters

Parameter Name	Parameter Meaning
IfIndex	Specifies an interface index.
hwIfMonitorOutputRatePercentage	Indicates statistics on outgoing traffic.
hwIfMonitorOutputRateThreshold	Specifies an alarm threshold for outgoing traffic.
InterfaceName	Specifies an interface name.

Possible Causes

The rate of traffic sent by the interface was too large.

Procedure

1. Run the display this interface command on the interface to check whether the traffic threshold is too low. The threshold range is specified by users according to actual services.

If so, go to Step 2.
If not, go to Step 3.

2. Run the trap-threshold output-rate bandwidth-in-use command to re-set the threshold and then check whether the alarm is cleared.

If so, go to Step 4.
If not, go to Step 3.

3. Collect alarm information and configuration information, and then contact technical support personnel.

4. End.