PORT/2/hwIfMonitorSdhB1ErrorRising_active

Message

PORT/2/hwIfMonitorSdhB1ErrorRising_active: The SDH B1 error is rising. (hwIfMonitorIndex=[hwIfMonitorIndex], hwIfMonitorSdhB1ErrorStatistics=[hwIfMonitorSdhB1ErrorStatistics], hwIfMonitorSdhB1ErrorThreshold=[hwIfMonitorSdhB1ErrorThreshold], hwIfMonitorSdhB1ErrorInterval=[hwIfMonitorSdhB1ErrorInterval],hwIfMonitorName=[hwIfMonitorName])

In VS mode, this log is supported only by the admin VS.

Description

The number of SDH B1 errors exceeded the preconfigured threshold in a specified period.

Parameters

Parameter Name	Parameter Meaning
hwIfMonitorIndex	Index of physical port.
hwIfMonitorSdhB1ErrorStatistics	Statistics about SDH B1 bit errors.
hwIfMonitorSdhB1ErrorThreshold	Maximum number of SDH B1 bit errors.
hwIfMonitorSdhB1ErrorInterval	Period during which the number of SDH B1 bit errors is counted.
hwIfMonitorName	Name of physical port.

Possible Causes

The link was of poor quality.

Procedure

1.Check whether the link (optical fiber, optic module, transmission device, jumper frame, etc) is faulty.

If the link is faulty, go to Step 2.
If the link is normal, go to Step 3.

2.Replace the faulty component and correctly connect the link, and check whether the alarm hwIfMonitorSdhB1ErrorResume is displayed.

If the alarm is displayed, go to End.
If the alarm is not displayed, go to Step 3.

3.Collect alarm information, log information and configuration information, and then contact technical support personnel.