L2VPN/3/hwL2vpnOamDloc_active

Message

L2VPN/3/hwL2vpnOamDloc_active: OAM reported an alarm about PW disconnection. (ServiceType=[ServiceType], ProtocolType=[ProtocolType], VcID=[VcID], VcType=[VcType], PeerAddr=[PeerAddr], IfIndex=[IfIndex], PwMaster=[PwMaster], RmtSiteID=[RmtSiteID], InLabel=[InLabel], OutLabel=[OutLabel], IfName=[IfName], VsiName=[VsiName])

Description

The PW connectivity status detected by OAM changed from Up to Down.

Parameters

Parameter Name	Parameter Meaning
ServiceType	Type of the service: 0: VPWS. 1: VPLS.
ProtocolType	Type of the protocol: 0: SVC. 1: LDP. 2: BGP (not supported for the time being).
VcID	VC ID.
VcType	VC type.
PeerAddr	IP address of the peer.
IfIndex	Interface index.
PwMaster	PW identifier: 1: primary PW. 2: secondary PW.
RmtSiteID	Remote site ID.
InLabel	VC in-label.
OutLabel	VC out-label.
IfName	Interface name.
VsiName	VSI name.

Possible Causes

Cause 1: MPLS OAM or MPLS-TP OAM configurations were incorrect.
Cause 2: The PW detected by OAM became faulty.

Procedure

1. If MPLS OAM is configured, run the display this command in the MPLS-OAM view to check MPLS OAM configurations.

If the configurations are correct, go to Step 2.
If the configurations are incorrect, go to Step 4.

2. If MPLS-TP OAM is configured, perform the troubleshooting operations described in hwMplsTpOamLossOfConnection to rectify the fault.

If the fault is rectified, go to Step 5.
If the fault persists, go to Step 3.

3. Perform the troubleshooting operations described in hwPWVcDown and hwSvcDown to rectify the fault.

If the fault is rectified, go to Step 5.
If the fault persists, go to Step 4.

4. Collect alarm information and configuration information, and then contact technical support personnel.

5. End.

ATN950B:

1. If MPLS-TP OAM is configured, perform the troubleshooting operations described in hwMplsTpOamLossOfConnection to rectify the fault.

If the fault is rectified, go to Step 4.
If the fault persists, go to Step 2.

2. Perform the troubleshooting operations described in hwPWVcDown and hwSvcDown to rectify the fault.

If the fault is rectified, go to Step 4.
If the fault persists, go to Step 3.

3. Collect alarm information and configuration information, and then contact technical support personnel.

4. End.