L2VPN/3/hwL2vpnOamMep_active

Message

L2VPN/3/hwL2vpnOamMep_active: OAM reported an unexpected MEP alarm. (ServiceType=[ServiceType], ProtocolType=[ProtocolType], VcID=[VcID], VcType=[VcType], PeerAddr=[PeerAddr], IfIndex=[IfIndex], PwMaster=[PwMaster], RmtSiteID=[RmtSiteID], InLabel=[InLabel], OutLabel=[OutLabel], IfName=[IfName], VsiName=[VsiName])

Description

OAM received unexpected MEP information.

Parameters

Parameter Name	Parameter Meaning
ServiceType	Type of the service: 0: VLL. 1: VPLS.
ProtocolType	Type of the protocol: 0: SVC. 1: LDP. 2: BGP (not supported for the time being).
VcID	VC ID.
VcType	VC type.
PeerAddr	IP address of the peer.
IfIndex	Interface index.
PwMaster	PW identifier: 1: primary PW. 2: secondary PW.
RmtSiteID	Remote site ID.
InLabel	VC in-label.
OutLabel	VC out-label.
IfName	Interface name.
VsiName	VSI name.

Possible Causes

The local and remote MEP IDs were different.

Procedure

1. Perform the troubleshooting operations described in hwMplsTpOamUnExpectMep to rectify the fault.

If the fault is rectified, go to Step 3.
If the fault persists, go to Step 2.

2. Collect alarm information and configuration information, and then contact technical support personnel.

3. End.