L2VPN/3/hwL2vpnOamRdi_active

Message

L2VPN/3/hwL2vpnOamRdi_active: OAM reported an alarm about a remote defect. (ServiceType=[ServiceType], ProtocolType=[ProtocolType], VcID=[VcID], VcType=[VcType], PeerAddr=[PeerAddr], IfIndex=[IfIndex], PwMaster=[PwMaster], RmtSiteID=[RmtSiteID], InLabel=[InLabel], OutLabel=[OutLabel], IfName=[IfName], VsiName=[VsiName])

Description

OAM reported an RDI alarm.

Parameters

Parameter Name	Parameter Meaning
ServiceType	Type of the service: 0: VLL. 1: VPLS.
ProtocolType	Type of the protocol: 0: SVC. 1: LDP. 2: BGP (not supported for the time being).
VcID	VC ID.
VcType	VC type.
PeerAddr	IP address of the peer.
IfIndex	Interface index.
PwMaster	PW identifier: 1: primary PW. 2: secondary PW.
RmtSiteID	Remote site ID.
InLabel	VC in-label.
OutLabel	VC out-label.
IfName	Interface name.
VsiName	VSI name.

Possible Causes

The remote end detected a LOC alarm and notified the local end.

Procedure

1. Perform the troubleshooting operations described in hwMplsTpOamRemoteDefectIndication to rectify the fault.

If the fault is rectified, go to Step 4.
If the fault persists, go to Step 2.

2. Perform the troubleshooting operations described in hwPWVcDown and hwSvcDown to rectify the fault.

If the fault is rectified, go to Step 4.
If the fault persists, go to Step 3.

3. Collect alarm information and configuration information, and then contact technical support personnel.

4. End.