L2VPN/3/hwL2vpnOamSd1Far_active

Message

L2VPN/3/hwL2vpnOamSd1Far_active: The OAM module reported an alarm, indicating that the far-end packet loss ratio exceeded the sd1 threshold. (ServiceType=[ServiceType], ProtocolType=[ProtocolType], VcID=[VcID], VcType=[VcType], PeerAddr=[PeerAddr], IfIndex=[IfIndex], PwMaster=[PwMaster], RmtSiteID=[RmtSiteID], InLabel=[InLabel], OutLabel=[OutLabel], IfName=[IfName], VsiName=[VsiName])

Description

The far-end packet loss ratio exceeded the SD1 threshold.

Parameters

Parameter Name	Parameter Meaning
ServiceType	Type of the service: 0: VLL. 1: VPLS.
ProtocolType	Type of the protocol: 0: SVC. 1: LDP. 2: BGP (not supported for the time being).
VcID	VC ID.
VcType	VC type.
PeerAddr	IP address of the peer.
IfIndex	Interface index.
PwMaster	PW identifier: 1: primary PW. 2: secondary PW.
RmtSiteID	Remote site ID.
InLabel	VC in-label.
OutLabel	VC out-label.
IfName	Interface name.
VsiName	VSI name.

Possible Causes

The far-end packet loss ratio exceeded the SD1(PTN and OSN are both SD) threshold.

Procedure

1. Perform the troubleshooting operations described in hwMplsTpOamFarDualLossSD1 to rectify the fault. Then, check whether the alarm is cleared.

If the alarm is cleared, go to Step 3.
If alarm persists, go to Step 2.

2. Collect alarm information and configuration information, and then contact technical support personnel.

3. End.