L2VPN/3/hwL2vpnOamSd2Far_active

Message

L2VPN/3/hwL2vpnOamSd2Far_active: The OAM module reported an alarm, indicating that the far-end packet loss ratio exceeded the sd2 threshold. (ServiceType=[ServiceType], ProtocolType=[ProtocolType], VcID=[VcID], VcType=[VcType], PeerAddr=[PeerAddr], IfIndex=[IfIndex], PwMaster=[PwMaster], RmtSiteID=[RmtSiteID], InLabel=[InLabel], OutLabel=[OutLabel], IfName=[IfName], VsiName=[VsiName])

Description

The far-end packet loss ratio exceeded the SD2 threshold.

Parameters

Parameter Name	Parameter Meaning
ServiceType	Type of the service: 0: VLL. 1: VPLS.
ProtocolType	Type of the protocol: 0: SVC. 1: LDP. 2: BGP (not supported for the time being).
VcID	VC ID.
VcType	VC type.
PeerAddr	IP address of the peer.
IfIndex	Interface index.
PwMaster	PW identifier: 1: primary PW. 2: secondary PW.
RmtSiteID	Remote site ID.
InLabel	VC in-label.
OutLabel	VC out-label.
IfName	Interface name.
VsiName	VSI name.

Possible Causes

The far-end packet loss ratio exceeded the SD2 (PTN and OSN are both SF) threshold.

Procedure

1. Perform the troubleshooting operations described in hwMplsTpOamFarDualLossSD2 to rectify the fault. Then, check whether the alarm is cleared.

If the alarm is cleared, go to Step 3.
If alarm persists, go to Step 2.

2. Collect alarm information and configuration information, and then contact technical support personnel.

3. End.