LDT/4/hwLoopDetectWithoutBlock_active

Message

LDT/4/hwLoopDetectWithoutBlock_active: The interface is in loop state. (PortIndex=[IfIndex], PortName=[IfName])

In VS mode, this log is supported only by the admin VS.

The interface is detected in loop state with the configuration of only send alarm.

Parameter Name	Parameter Meaning
IfIndex	Interface Index.
IfName	Interface Name.

Cause 1: A loop was detected on the interface.

Cause 2: The interface enable the loop-detect function.

Cause3:The interface enable loop-detect only-alarm function.

1. Run the display loop-detect block all command to check whether loops occur on the interface and the Layer 2 network connected to the interface.

2. Collect trap, log, and configuration information, and contact technical engineer support personnel.

3. End.