L2IF/4/hwMacHopAlarm_active: Mac-hopping exist.(VlanId=[VlanId], Vsi=[vsi_name], BDId=[BD_ID], the port list of Mac-hopping = [PortName1], [PortName2], [PortName3], [PortName4], the peer list of Mac-hopping = [PeerList], DetectMac = [DetectMac], trustport = [TrustPortName], trustpeer = [TrustPeerInfo])
In VS mode, this log is supported only by the admin VS.
MAC flapping-based loop detection is enabled by default. An alarm is generated when MAC flapping reaches the configured alarm threshold.
| Parameter Name | Parameter Meaning |
|---|---|
|
VlanId |
VLAN ID of the broadcast domain. |
|
vsi_name |
VSI name. |
|
BD_ID |
BD ID. |
|
PortName1 |
The mac flapping interface. |
|
PortName2 |
The mac flapping interface. |
|
PortName3 |
The mac flapping interface. |
|
PortName4 |
The mac flapping interface. |
|
PeerList |
The peer information of Mac-hopping. |
|
DetectMac |
Detect Mac. |
|
TrustPortName |
Trustport |
|
TrustPeerInfo |
Trustpeer |
MAC address transition frequently occurred in the broadcast domain. A Layer 2 loop may exist.
1.Check that the source interface corresponding to the transited MAC address is correctly configured.
2.Check that the source interface corresponding to the transited MAC address is correctly connected.
3.Enable MAC flapping to block the corresponding source interface.
4.Collect alarm information, log information and configuration information, and then contact technical support personnel.