L2VPN/4/hwMacLimitRuleNumRaisingThreshold_active: The mac address learned by the board is beyond the threshold of the global mac limit rule. (EntPhysicalIndex=[hwEntPhysicalIndex], PhysicalName=[hwPhyscialName], RuleName=[rule_name], LearnNumber=[learn_number], LimitNumber=[limit_number])
In VS mode, this log is supported only by the admin VS.
A global MAC address learning limit rule is configured on the board. An alarm is generated when the number of MAC addresses learned on the board exceeds the alarm threshold specified in the rule.
| Parameter Name | Parameter Meaning |
|---|---|
|
hwEntPhysicalIndex |
Index of a physical entity. |
|
hwPhyscialName |
Name of a physical entity. |
|
rule_name |
Name of the global MAC address limit rule. |
|
learn_number |
Number of learned MAC addresses. |
|
limit_number |
Limit on the number of learned MAC addresses. |
A global MAC address limit was configured and enabled, and the number of learned dynamic MAC addresses reached the limit.
1.This trap message is informational only. Go to step 2 if you need to clear the trap.
2.Perform either of the following configurations: Run the undo mac-address command in the system view to delete useless MAC address entries. Run the mac-limit rule-name maximum command in the system view to configure the maximum number of MAC addresses learned by the global MAC address limit rule. Then, check whether the trap is cleared.
3.Collect trap, log, and configuration information, and contact technical support personnel.
4.End.