IGMP/4/hwMgmdIfThresholdExceed_active

Message

IGMP/4/hwMgmdIfThresholdExceed_active: The number of IGMP or MLD entries on the interface reached the upper threshold. (AddressFamily=[AddressFamily], Ifindex=[IfIndex], CurrentCount=[CurrentCount], ThresholdCount=[ThresholdCount], Ifname=[IfName], InstanceName=[InstanceName])

Description

The number of IGMP/MLD entries on the interface reached the upper threshold.

Parameters

Parameter Name	Parameter Meaning
AddressFamily	Address family: 1: IPv4 family. 2: IPv6 family.
IfIndex	interface index.
CurrentCount	Number of IGMP/MLD entries on the current interface. The IGMP/MLD entries that are newly added are not included.
ThresholdCount	Threshold at which the alarm is generated .
IfName	Name of the interface.
InstanceName	Instance of which the number of created (S, G) entries on the device reaches the specified limit.

Possible Causes

Cause 1: Entry create
Cause 2: Configuration change

Procedure

Cause 1: Entry create
1. Run the display igmp interface command to check whether the value of igmp access-limit is set to a small number.
- If the value of igmp access-limit is set to a small number, go to Step 2.
- If the value of igmp access-limit is not set to a small number, go to Step 3.
2. Run the igmp access-limit command to adjust the entry limit and check whether the fault is rectified.
- If the fault is rectified, go to Step 4.
- If the fault is not rectified, go to Step 3.
3. Collect alarm information and configuration information, and then contact technical support personnel.

4. End.
Cause 2: Configuration change
The same as Cause 1.