FEI_L2/4/hwModeChannelBandwidthAlarm_active

Message

FEI_L2/4/hwModeChannelBandwidthAlarm_active: The total bandwidth of the channelized sub-interfaces on the same physical or Eth-Trunk interface has exceeded the maximum available bandwidth of the physical or Eth-Trunk interface. (Interface=[IfIndex], Bandwidth=[Bandwidth], SubIfBandwidthSum=[SubIfBandwidthSum], InterfaceName=[InterfaceName])

Description

The total bandwidth of the channelized sub-interfaces on the same physical or Eth-Trunk interface has exceeded the maximum available bandwidth of the physical or Eth-Trunk interface.

Parameters

Parameter Name	Parameter Meaning
IfIndex	Interface index
Bandwidth	available bandwidth of the physical or Eth-Trunk interface
SubIfBandwidthSum	The total bandwidth of the channelized sub-interfaces
InterfaceName	Interface name

Possible Causes

The total bandwidth of the channelized sub-interfaces on the same physical or Eth-Trunk interface has exceeded the maximum available bandwidth of the physical or Eth-Trunk interface.

Procedure

1. Run the mode channel bandwidth command in the sub-interface view to set the bandwidth of the channelized sub-interface to a smaller value. Then check whether the alarm is cleared.

If the alarm is cleared, go to Step 3.
If the alarm persists, go to Step 2.

2. Collect the trap information, log information, and configuration information, and then contact technical support personnel.

3. End.