MPLS_LSPM/3/hwMplsOamBDI_active

Message

MPLS_LSPM/3/hwMplsOamBDI_active: The tunnel receives a BDI alarm. (SessionTunnelId=[SessionTunnelId], LocalLspId=[LocalLspId], IngressLsrId=[IngressLsrId], EgressLsrId=[EgressLsrId], IfIndex=[OutIfIndex], TunnelName=[TunnelName], SignalingProtocol=[SgnlPrtcl], IfName=[OutIfName], SignalledTunnelName=[SignalledTunnelName])

Description

A BDI alarm about an MPLS tunnel was generated.

Parameters

Parameter Name	Parameter Meaning
SessionTunnelId	Tunnel ID
LocalLspId	Local LSP ID
IngressLsrId	ID of the ingress LSR
EgressLsrId	ID of the egress LSR
OutIfIndex	Index of the interface
TunnelName	Tunnel name
SgnlPrtcl	Tunneling protocol
OutIfName	The name of the interface
SignalledTunnelName	Tunnel alias.

Possible Causes

An MPLS tunnel is faulty. The egress sends a BDI notification to the ingress.

Procedure

1. Run the display interface command to check whether any physical interface connected to the MPLS tunnel is shut down.

If so, go to Step 2.
If not, go to Step 3.

2. Run the undo shutdown command to enable the physical interface. Then check whether the alarm is cleared.

If so, go to Step 5.
If not, go to Step 4.

3. If all configurations are correct, the MPLS tunnel is faulty. Then go to Step 4.

4. Collect the trap information, log information, and configuration information, and then Collect alarm information and configuration information, and then contact technical support personnel..

5. End.