MPLS_LSPM/3/hwMplsOamExcess_active

Message

MPLS_LSPM/3/hwMplsOamExcess_active: The tunnel receives an Excess alarm. (SessionTunnelId=[SessionTunnelId], LocalLspId=[LocalLspId], IngressLsrId=[IngressLsrId], EgressLsrId=[EgressLsrId], TunnelName=[TunnelName], SignalingProtocol=[SgnlPrtcl], SignalledTunnelName=[SignalledTunnelName])

Description

OAM detection periods on two ends of an MPLS tunnel were different.

Parameters

Parameter Name	Parameter Meaning
SessionTunnelId	Tunnel ID
LocalLspId	Local LSP ID
IngressLsrId	ID of the ingress LSR
EgressLsrId	ID of the egress LSR
TunnelName	Tunnel name
SgnlPrtcl	Tunneling protocol
SignalledTunnelName	Tunnel alias.

Possible Causes

1. The tunnels were configured incorrectly. Multiple tunnels had the same labels and IDs configured.

2. Physical links were incorrectly connected.

Procedure

1. Run the display current-configuration command to check whether the specified OAM detection periods are the same.

If so, go to Step 3.
If not, go to Step 2.

2. Re-set the OAM detection periods on both ends. Then check whether MPLS_LSPM_1.3.6.1.4.1.2011.5.25.121.2.1.35 hwMplsOamExcessRecovery is reported.

If so, go to Step 4.
If not, go to Step 3.

3. Collect the trap information, log information, and configuration information, and then Collect alarm information and configuration information, and then contact technical support personnel..

4. End.