MPLS_LSPM/2/hwMplsOamFDI_active

Message

MPLS_LSPM/2/hwMplsOamFDI_active: The tunnel receives an FDI alarm. (SessionTunnelId=[SessionTunnelId], LocalLspId=[LocalLspId], IngressLsrId=[IngressLsrId], EgressLsrId=[EgressLsrId], IfIndex=[IfIndex], TunnelName=[TunnelName], SignalingProtocol=[SgnlPrtcl], IfName=[IfName], SignalledTunnelName =[SignalledTunnelName])

Description

An FDI alarm was generated on the tunnel.

Parameters

Parameter Name	Parameter Meaning
SessionTunnelId	Tunnel Id
LocalLspId	Local Lsp Id
IngressLsrId	Ingress Lsr Id
EgressLsrId	Egress Lsr Id
IfIndex	Interface Index
TunnelName	Tunnel Name
SgnlPrtcl	Tunnel Signal Protocol Ranges: 1:RSVP 2:STATIC 3:CRSTATIC
IfName	Interface Name
SignalledTunnelName	User-Defined Tunnel Name
TunnelDirection	Tunnel Direction

Possible Causes

The upstream P device detected a failure at the physical layer, for example, a fiber cut.

Procedure

1. Check that no fault (for example, optical fiber disconnect) occurs at the physical layer of each upstream node.

If such a fault does not exist, go to Step 3.
If such a fault exists, go to Step 2.

2. Rectify the fault on the physical layer of the upstream node by replacing the faulty component. Then check whether the alarm is cleared.

If the alarm is cleared, go to Step 4.
If the alarm persists, go to Step 3.

3. Collect log information and configuration information, and then contact technical support personnel.

4. End.