MPLS_LSPM/1/hwMplsOamMeg_active

Message

MPLS_LSPM/1/hwMplsOamMeg_active: The tunnel receives a MEG alarm.(SessionTunnelId=[SessionTunnelId], LocalLspId=[LocalLspId], IngressLsrId=[IngressLsrId], EgressLsrId=[EgressLsrId], TunnelName=[TunnelName], SignalingProtocol=[SgnlPrtcl], SignalledTunnelName=[SignalledTunnelName])

Description

Inconsistent MEG configurations on both ends of an MPLS tunnel were detected.

Parameters

Parameter Name	Parameter Meaning
SessionTunnelId	Tunnel ID
LocalLspId	Local LSP ID
IngressLsrId	ID of the ingress LSR
EgressLsrId	ID of the egress LSR
TunnelName	Tunnel name
SgnlPrtcl	Signaling protocol used by a tunnel session including: - 1: RSVP - 2: STATIC - 3: CRSTATIC PTN7900,PTN9X0: - 1: RSVP - 2: STATIC - 3: CRSTATIC - 4: SEGMENT_ROUTING
SignalledTunnelName	Tunnel alias.

Possible Causes

Names of the ingress and egress MEGs are different.

Procedure

1. Run the display current-configuration command to check whether names of the ingress and egress MEGs are the same. - If so, go to Step 3. - If not, go to Step 2. 2. Configure a same name for the ingress and egress MEGs. - Then check whether MPLS_LSPM_1.3.6.1.4.1.2011.5.25.121.2.1.25 hwMplsOamMegRecovery is generated. - If so, go to Step 4. - If not, go to Step 3. 3. Collect alarm information and configuration information, and then contact technical support personnel. 4. End.