MPLS_LSPM/2/hwMplsOamMep_active

Message

MPLS_LSPM/2/hwMplsOamMep_active: The tunnel receives a MEP alarm. (SessionTunnelId=[SessionTunnelId], LocalLspId=[LocalLspId], IngressLsrId=[IngressLsrId], EgressLsrId=[EgressLsrId], TunnelName=[TunnelName], SignalingProtocol=[SgnlPrtcl])

Description

MEP IDs on two ends of an MPLS tunnel were different.

Parameters

Parameter Name	Parameter Meaning
SessionTunnelId	Tunnel ID
LocalLspId	Local LSP ID
IngressLsrId	ID of the ingress LSR
EgressLsrId	ID of the egress LSR
TunnelName	Tunnel name
SgnlPrtcl	Tunneling protocol
LsrRole	Lsp Lsr Role.

Possible Causes

IDs of the ingress and egress MEPs are different.

Procedure

1. Run the display current-configuration command to check whether IDs of the ingress and egress MEPs are the same.

If so, go to Step 3.
If not, go to Step 2.

2. Set a same ID for the ingress and egress MEPs.

Then check whether MPLS_LSPM_1.3.6.1.4.1.2011.5.25.121.2.1.27 hwMplsOamMepRecovery is reported.
If so, go to Step 4.
If not, go to Step 3.

3. Collect the trap information, log information, and configuration information, and then Collect alarm information and configuration information, and then contact technical support personnel..

4. End.