MPLS_LSPM/2/hwMplsOamMisMerge_active

Message

MPLS_LSPM/2/hwMplsOamMisMerge_active: The tunnel receives a MisMerge alarm. (SessionTunnelId=[SessionTunnelId], LocalLspId=[LocalLspId], IngressLsrId=[IngressLsrId], EgressLsrId=[EgressLsrId], TunnelName=[TunnelName], SignalingProtocol=[SgnlPrtcl], SignalledTunnelName=[SignalledTunnelName])

Description

Both correct and incorrect packets were received in three consecutive periods.

Parameters

Parameter Name	Parameter Meaning
SessionTunnelId	Tunnel ID
LocalLspId	Local LSP ID
IngressLsrId	ID of the ingress LSR
EgressLsrId	ID of the egress LSR
TunnelName	Tunnel name
SgnlPrtcl	Tunneling protocol
SignalledTunnelName	Tunnel alias.

Possible Causes

Both correct and incorrect packets are received in three consecutive periods.

Procedure

1. Run the display mpls oam ingress and display mpls oam egress commands to check whether OAM detection configurations on both ends are the same.

If so, go to Step 3.
If not, go to Step 2.

2. Reconfigure the OAM function on both ends. Then check whether MPLS_LSPM_1.3.6.1.4.1.2011.5.25.121.2.1.39 hwMplsOamMisMergeRecovery is reported.

If so, go to Step 4.
If not, go to Step 3.

3. Collect the trap information, log information, and configuration information, and then Collect alarm information and configuration information, and then contact technical support personnel..

4. End.