MPLS_LSPM/2/hwMplsOamPeriod_active

Message

MPLS_LSPM/2/hwMplsOamPeriod_active: The tunnel receives a period inconsistency alarm. (SessionTunnelId=[SessionTunnelId], LocalLspId=[LocalLspId], IngressLsrId=[IngressLsrId], EgressLsrId=[EgressLsrId], TunnelName=[TunnelName], SignalingProtocol=[SgnlPrtcl], SignalledTunnelName=[SignalledTunnelName])

Description

CC detection periods on two ends of an MPLS tunnel were different.

Parameters

Parameter Name	Parameter Meaning
SessionTunnelId	Tunnel ID
LocalLspId	Local LSP ID
IngressLsrId	ID of the ingress LSR
EgressLsrId	ID of the egress LSR
TunnelName	Tunnel name
SgnlPrtcl	Tunneling protocol
SignalledTunnelName	Tunnel alias.

Possible Causes

The CC detection period of the local end is different from that of the peer end.

Procedure

1. Run the display current-configuration command to check whether the CC detection periods of the local and peer ends are the same.

If so, go to Step 3.
If not, go to Step 2.

2. Configure a same CC detection period for the local and peer ends.

Then check whether MPLS_LSPM_1.3.6.1.4.1.2011.5.25.121.2.1.31 hwMplsOamPeriodRecovery is reported.
If so, go to Step 4.
If not, go to Step 3.

3. Collect the trap information, log information, and configuration information, and then Collect alarm information and configuration information, and then contact technical support personnel..

4. End.