TPOAM/4/hwMplsTpOamFarDualLossSD2

Message

TPOAM/4/hwMplsTpOamFarDualLossSD2: Signal Degraded threshold2 far-end alarm start. (MegId=[MegId], MegId=[Meg_Id], MeIndex=[MeIndex], MeType=[MeType], MeDirection=[MeDirection], IfName=[IfName], PeerIP=[PeerIP], VcId=[VcId], VcType=[VcType], RemoteIp=[RemoteIp], Ttl=[Ttl], MepId=[MepId], RemoteMepId=[RemoteMepId], CurrentLoss=[CurrentLoss], Threshold=[Threshold], LspName=[LspName], VsiName=[VsiName])

Description

TP OAM detected that the number of frames lost on the RMEP exceeded the configured SD2 threshold.

Parameters

Parameter Name	Parameter Meaning
MegId	Name of a MEG
Meg_Id	Name of a MEG
MeIndex	Index of an ME
MeType	ME type: 1: PW VLL 2: PW VSI 3: TE -CR LSP 4: Section 5: Associate
MeDirection	Tunnel type for an ME: ingress egress dual
IfName	Interface name
PeerIP	Peer IP address
VcId	VC ID
VcType	VC type
RemoteIp	IP address of an RMEP
Ttl	TTL value
MepId	Local ME ID
RemoteMepId	RMEP ID
CurrentLoss	Current frame loss ratio
Threshold	Frame loss alarm threshold
LspName	LSP name
VsiName	VSI name

Possible Causes

The number of frames lost on the RMEP exceeded the configured SD2 threshold.

Procedure

1. Run the display current-configuration command to check whether the alarm threshold for frame LM is configured correctly.

If the alarm threshold for frame LM is configured correctly, go to Step 3.
If the alarm threshold for frame LM is not configured correctly, go to Step 2.

2. Collect log information and configuration information, and then contact technical support personnel.

3. End.