TPOAM/4/hwMplsTpOamUnExpectMeg

Message

TPOAM/4/hwMplsTpOamUnExpectMeg: unexpected MEG alarm start. (MegId=[MegId], MegId=[Meg_Id], MeIndex=[MeIndex], MeType=[MeType], MeDirection=[MeDirection], IfName=[IfName], PeerIP=[PeerIP], VcId=[VcId], VcType=[VcType], RemoteIp=[RemoteIp], Ttl=[Ttl], MepId=[MepId], RemoteMepId=[RemoteMepId], LspName=[LspName], VsiName=[VsiName])

Description

TP OAM detected that the MEG configurations on both ends were different.

Parameters

Parameter Name	Parameter Meaning
MegId	Name of a MEG
Meg_Id	Name of a MEG
MeIndex	Index of an ME
MeType	ME type: 1: PW VLL 2: PW VSI 3: TE -CR LSP 4: Section 5: Associate
MeDirection	Tunnel type for an ME: ingress egress dual
IfName	Interface name
PeerIP	Peer IP address
VcId	VC ID
VcType	VC type
RemoteIp	IP address of an RMEP
Ttl	TTL value
MepId	Local ME ID
RemoteMepId	RMEP ID
LspName	LSP name
VsiName	VSI name

Possible Causes

The MEG names configured on the MEP and RMEP were different.

Procedure

1. Run the display current-configuration command to check whether the MEG configurations on both ends are the same.

If they are the same, go to Step 3.
If they are different, go to Step 2.

2. Reconfigure the MEGs on the MEP and RMEP, and check whether the alarm is cleared.

If the alarm is cleared, go to Step 4.
If the alarm is not cleared, go to Step 3.

3. Collect log information and configuration information, and then contact technical support personnel.

4. End.