DEVM/1/hwRemoteFaultAlarm_active

Message

DEVM/1/hwRemoteFaultAlarm_active: The remote fault alarm has occurred. (IfIndex=[hwPhysicalPortIfIndex], IfName=[hwPhysicalPortName])

Description

The remote fault alarm.

Parameters

Parameter Name	Parameter Meaning
hwPhysicalPortIfIndex	Index of physical port.
hwPhysicalPortName	Name of physical port.

Possible Causes

This alarm is generated may because the optical fiber for sending traffic to the remote end was pulled out.

Procedure

1.Check whether the optical fiber is faulty. If the optical fiber is working properly, go to Step 2. If the optical fiber is faulty, replace it. Then check whether the alarm is cleared.

If the alarm is cleared, go to End.
If the alarm is not cleared, go to Step 2.

2.Check whether the optical modules on both ends are faulty. If the optical modules on both ends are working properly, go to Step 3. If an optical module is faulty, replace it. Then check whether the alarm is cleared.

If the alarm is cleared, go to End.
If the alarm is not cleared, go to Step 3.

3.Check whether the board on the remote end is faulty. If the board is working properly, go to Step 4. If the board is faulty, replace it. Then check whether the alarm is cleared.

If the alarm is cleared, go to End.
If the alarm is not cleared, go to Step 4.

4.Collect alarm information, log information and configuration information, and then contact technical support personnel.

5.End.