Configuring CU-106 on an Interface

After enabling CU-106 in the system view, you need to enable CU-106 in the interface view.

Perform the following operations on the T-BC and T-TC:

Run system-view
The system view is displayed.
Run interface interface-type interface-number
The interface view is displayed.
Run ptp enable
PTP is enabled on the interface.
(Optional) Run ptp local-priority local-priority-value
The local priority of a PTP interface is set.
(Optional) Run ptp asymmetry-correction { positive | negative } correction-value
The asymmetric correction time for sending CU-106 packets on the interface is set.
(Optional) Run ptp clock-step { one-step | two-step }
The timestamping mode of the synchronization packets sending by the CU-106 port is set.
Run commit
The configuration is committed.