Configuring Global Padding

This section describes how to configure global padding.

Usage Scenario

  1. By default, port padding is enabled for all MAC module.
  2. If there are a large number of outbound packets containing less than 42 bytes, the highest forwarding performance of some MAC module can be achieved only when global padding is enabled for the subcards.
  3. By default, global padding is disabled.

In VS mode, this configuration task is supported only by the admin VS.

Pre-configuration Tasks

None

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run set mac-padding enable

    The padding function is configured.

  3. Run commit

    The configuration is committed.

Verifying the Configuration

After configuring global padding, check the configurations.

Run the display this command to check whether the function is successfully configured.

Parent Topic: Device Management Configuration
Copyright © Huawei Technologies Co., Ltd.
Copyright © Huawei Technologies Co., Ltd.
< Previous topic Next topic >