Configuring Layer 3 Loop Detection
Layer 3 loop detection reports traps when detecting a routing loop so that you can take rapid measures to ensure proper service running.
Usage Scenario
The Layer 3 loop detection function detects whether a loop exists on a network. If a routing loop is detected, the device generates reports a trap.
Perform the following operations when no routing loop trap information is required.
To ensure network reliability, exercise caution when running the l3-loop-detect disable command.
In VS mode, this feature is supported only by the admin VS.
Procedure
- Run system-view
The system view is displayed.
- Run l3-loop-detect disable
Layer 3 loop detection is disabled.
- Run commit
The configuration is committed.