Configuring a MAP-BR

Configuring a BMR

This section describes how to configure a basic mapping rule (BMR). A BMR is used to convert user-side IPv6 addresses into IPv4 addresses and network-side IPv4 addresses into IPv6 addresses.

Configuring a BR

A border relay (BR) is created. The MAP-CE encapsulates an IPv6 prefix defined based on the BR into traffic and directs the traffic to an interface board. The MAP-CE then selects a MAP-E instance to convert the traffic.

Binding a BR to a MAP-E Instance

This section describes how to bind a BR to a MAP-E instance so that a MAP-CE selects a MAP-E instance to convert IPv6 packets after MAP processing.

Binding a BMR to a MAP-E Instance

This section describes how to bind a BMR to a MAP-E instance. The BMR is used to encapsulate and verify packets in the MAP-E instance.

(Optional) Setting an MSS Value for MAP-E Services

The maximum segment size (MSS) value defined in TCP specifies the maximum length of a TCP packet to be sent without fragmentation. Two devices exchange SYN packets to negotiate the MSS value for a TCP connection to be established. If the size of packets for MAP processing is larger than a link MTU, the packets are fragmented. You can reduce the MSS value in TCP, which prevents a service board from fragmenting packets and helps improve MAP efficiency.

(Optional) Setting an MTU for IPv6 Packets

This section describes how to set a maximum transmission unit. Whether to fragment translated packets depends on the smaller value between the MTU configured in an instance and the interface MTU. To customize the MTU value of the IPv6 packets in a MAP instance, set the MTU value in the MAP instance.

(Optional) Setting the Traffic Class of IPv6 Packets

When an IPv4 packet is translated into an IPv6 packet, the Traffic-Class field value in the IPv6 packet is copied from the ToS field in the IPv4 packet. To modify the traffic class of IPv6 packets, set the traffic class value of IPv6 packets in an instance.