The system view is displayed.
The Eth-Trunk interface view is displayed.
Run mode { lacp-static | manual load-balance }
The working mode of the Eth-Trunk interface is set.
The Eth-Trunk member interface view is displayed.
(Optional) Run distribute-weight weight-value
The distribute-weight of the member interface is set.
By default, the weight of an Eth-Trunk member interface is 1.
The higher the weight of a member interface, the heavier the load over the member link.
A maximum of 64 member interfaces in an Eth-Trunk interface can carry out load balancing. The total weights of all member interfaces in an Eth-Trunk interface cannot be greater than 64.
When multicast traffic is transmitted over an Eth-Trunk interface, if the distribute-weight command is used to change the weight of a member interface, you need to run the shutdown and then undo shutdown commands to restart the member interface for the configuration to take effect.
The configuration is committed.
The system view is displayed.
The VLAN or VSI view is displayed.
Run trunk multicast load-balance enable
Trunk multicast load-balance is enabled.
By default, trunk load balancing is not enabled for Layer 2 multicast.
In the same VLAN or VSI, the trunk load balancing function for Layer 2 multicast and IGMP snooping are mutual exclusive. They cannot be configured concurrently.
The configuration is committed.
Run the save command to save the current configuration to the configuration file when a set of configuration is finished and the expected functions have been achieved.