Feature Requirements |
Series |
Models |
|---|---|---|
1. Configuration rollback is performed using commands. If configuration differences still exist after the rollback, the system prompts you to check the configurations that are not rolled back. However, the operation is recorded as successful in the operation log. 2. When configuration rollback using NETCONF is finished, the system displays a rollback success message if the configuration difference exists. You can check for differences between the target rollback point and current configurations to determine whether all configurations have been rolled back. 3. During configuration rollback, do not perform operations such as inserting, replacing, or resetting boards. If such an operation is performed, the board fails to be registered. |
NetEngine 8000 F |
NetEngine 8000 F2A/NetEngine 8000 F1A |
When the system is committing configurations or rolling back, there is a possibility that the board that is newly started cannot register for a long time. |
NetEngine 8000 F |
NetEngine 8000 F2A/NetEngine 8000 F1A |
After a device is restarted, the current running configurations cannot be queried when configuration data is being restored. |
NetEngine 8000 F |
NetEngine 8000 F2A/NetEngine 8000 F1A |
After a device is restarted, configurations cannot be saved when configuration data is being restored. |
NetEngine 8000 F |
NetEngine 8000 F2A/NetEngine 8000 F1A |
If multiple users commit configurations at the same time, the operation may fail due to the conflict. A message indicating that the system is busy is displayed. Configurations need to be committed again. |
NetEngine 8000 F |
NetEngine 8000 F2A/NetEngine 8000 F1A |
After a device is restarted, configurations cannot be committed when configuration data is being restored. |
NetEngine 8000 F |
NetEngine 8000 F2A/NetEngine 8000 F1A |
Configuration change is not allowed when an NMS initiates full synchronization to the device. |
NetEngine 8000 F |
NetEngine 8000 F2A/NetEngine 8000 F1A |
In two-phase configuration validation mode, the number of uncommitted configurations is limited. |
NetEngine 8000 F |
NetEngine 8000 F2A/NetEngine 8000 F1A |
When you edit the configuration, if the memory usage of the master main control board on the current device exceeds 90%, the configuration command fails to be executed. |
NetEngine 8000 F |
NetEngine 8000 F2A/NetEngine 8000 F1A |
When a configuration difference comparison command is run, if repeated commands exist in the same view, the current command fails to be executed. |
NetEngine 8000 F |
NetEngine 8000 F2A/NetEngine 8000 F1A |
The user cannot modify configurations during the system trail running. After the trial run command is executed to enable the device to enter the trial running state, only the current trial running user can modify the configuration. Other users cannot modify the configuration during the trial run. |
NetEngine 8000 F |
NetEngine 8000 F2A/NetEngine 8000 F1A |