Feature Requirements |
Series |
Models |
|---|---|---|
MPLS OAM is configured for a tunnel, and bit-error-triggered protection switching is configured on an interface. The tunnel interface sends a backward defect indication (BDI) packet carrying defect information to the peer end through a reverse tunnel. After receiving the BDI packet, the peer end sets the status of all PWs in the tunnel to Down. As a result, service traffic is interrupted. Suggestion 1: 1. If no protection is configured, do not enable bit-error-triggered switching on an interface. 2. In a scenario where protection is configured, bit-error-triggered protection switching is enabled only on the working path. 3. In APS non-revertive mode, bit errors may occur and traffic cannot be switched back to the working link even if the working link recovers. Therefore, you are not advised to deploy APS non-revertive mode. Suggestion 2: The OAM mode of the tunnel is set to 1731 (TPOAM). |
NetEngine 8000 F |
NetEngine 8000 F1A |
MPLS OAM single-ended packet loss measurement does not support the scenario where the detected service has multiple outbound interfaces that reside on different boards or chips. The typical scenario is public network load balancing or public network Eth-Trunk interfaces. |
NetEngine 8000 F |
NetEngine 8000 F1A |