Configuring BGP MVPN Peer Relationships

BGP MVPN peer relationships between PEs in the same MVPN allow the PEs to exchange MVPN A-D routes and C-multicast routes.

Prerequisites

Before configuring BGP MVPN peers, configure L3VPNv6/EVPN L3VPNv6 over SRv6. For details, see the configuration examples in this document.

Context

In the typical MVPNv6 over BIERv6 networking shown in Figure 1, one sender PE and multiple receiver PEs are deployed. Because multicast traffic is transmitted between the multicast source and receivers, BGP MVPN peer relationships must be established between the sender PE and all receiver PEs.

Figure 1 MVPNv6 over BIERv6 networking
Click to enlarge

Procedure

Configure the sender PE.
1. Run system-view
  The system view is displayed.
2. Run bgp as-number
  The BGP view is displayed.
3. Run ipv6-family mvpn
  The BGP-IPv6 MVPN address family view is displayed.
4. Run peer ipv6-address enable
  The sender PE is enabled to establish a BGP MVPN peer relationship with a specified receiver PE. You need to run this command for each receiver PE with which the sender PE needs to establish a BGP MVPN peer relationship.
  
  It is recommended that the IPv6 address be set to the loopback interface address of each receiver PE.
5. Run quit
  Exit the BGP-IPv6 MVPN address family view.
6. Run quit
  Exit the BGP view.
7. Run commit
  The configuration is committed.
Configure a receiver PE.
Perform the following operations on all receiver PEs.
1. Run system-view
  The system view is displayed.
2. Run bgp as-number
  The BGP view is displayed.
3. Run ipv6-family mvpn
  The BGP-IPv6 MVPN address family view is displayed.
4. Run peer ipv6-address enable
  The receiver PE is enabled to establish a BGP MVPN peer relationship with the sender PE.
  
  It is recommended that the IPv6 address be set to the loopback interface address of the sender PE.
5. Run quit
  Exit the BGP-IPv6 MVPN address family view.
6. Run quit
  Exit the BGP view.
7. Run commit
  The configuration is committed.