After configuring an MVPNv6 over BIERv6 network, check the committed configurations and whether they have taken effect.
Procedure
- Run the display bgp mvpn vpnv6 all peer command to check information about BGP-IPv6 MVPN peers.
- Run the display multicast ipv6 routing-table command to check information about the IPv6 multicast routing table.
- Run the display multicast ipv6 rpf-info ipv6-source-address [ ipv6-group-address ] [ rpt | spt ] [ verbose ] command to check RPF routing information of a specified IPv6 multicast source.
- Run the display mvpn ipv6 { all-instance | vpn-instance vpn-instance-name } ipmsi [ verbose [ grpAddr | srcAddr ] * ] command on a sender PE or receiver PE to check I-PMSI tunnel information of a specified VPN instance.
- Run the display mvpn ipv6 { all-instance | vpn-instance vpn-instance-name } spmsi [ verbose [ grpAddr | srcAddr ] * ] command on a sender PE or receiver PE to check S-PMSI tunnel information of a specified VPN instance.
- Run the display pim ipv6 routing-table command to check the IPv6 PIM routing table.
- Run the display pim ipv6 claimed-route [ ipv6-source-address ] command to check information about the IPv6 unicast routes used by IPv6 PIM.