If the clients of a route reflector are fully connected, you need to disable route reflection among them through the RR to reduce bandwidth consumption.
On some networks, if fully meshed IBGP connections have been established between clients, they can directly exchange routing information. Therefore, route reflection between clients through the RR is unnecessary, which also occupies bandwidth. In this case, disable route reflection among them through the RR.
The system view is displayed.
The BGP view is displayed.
The IPv4 unicast address family view is displayed.
Route reflection is disabled among clients through the RR.
If the clients of the route reflector are fully connected, you can use the undo reflect between-clients command to disable route reflection among the clients through the RR. This command is applicable to only the route reflector.
The configuration is committed.