After configuring intra-AS segmented NG MVPN, verify information about BGP MVPN peer relationships, I-PMSI tunnels, and VPN instances' PIM routing tables on PEs.
Prerequisites
Intra-AS segmented NG MVPN has been configured.
Procedure
- Run the display bgp mvpn all peer [ [ ipv4-address ] verbose ] command to check BGP MVPN peer relationship information.
- Run the display mvpn vpn-instance vpn-instance-name ipmsi [ verbose [ grpAddr | srcAddr] * ] command to check I-PMSI tunnel configurations for the MVPN service of a specified VPN instance.
- Run the display mvpn { vpn-instance vpn-instance-name | all-instance } spmsi [ verbose [ grpAddr | srcAddr ] * ] command to check S-PMSI tunnel configurations for the MVPN service of a specified VPN instance.
- Run the display pim { vpn-instance vpn-instance-name | all-instance } routing-table command to check PIM routing entries of a specified or all VPN instances.
- Run the following commands to check multicast LSP information.
- Run the display mpls multicast-lsp protocol mldp p2mp [ root-ip root-ip-address { lsp-id lsp-id | opaque-value opaque-value } ] [ lsr-role { bud | ingress | transit | egress } ] command to check P2MP mLDP LSP information.
- Run the display mpls multicast-lsp protocol p2mp-te [ lsp-id ingress-lsr-id session-id p2mp-id lsp-id [ s2l-destination s2l-destination-address ] ] command to check P2MP RSVP-TE LSP information.
- Run the display mvpn inter-region-segmented { spmsi [ route-distinguisher route-distinguisher source source-address group group-address ] | ipmsi [ route-distinguisher route-distinguisher ] } command to check I-PMSI or S-PMSI tunnel stitching information and leaf information on the node connected to the tunnel.