Verifying the Configuration of the Eth-Trunk Interface in Static LACP Mode

After an Eth-Trunk interface is configured in static LACP mode, verify the configuration, including the interface ID, working mode, member interface status, LACP system priority, LACP interface priority, and LACP preemption delay.

Prerequisites

An Eth-Trunk interface has been configured in static LACP mode.

Procedure

  • Run the display trunkmembership eth-trunk trunk-id command to check information about member interfaces of the Eth-Trunk interface.
  • Run the display eth-trunk [ trunk-id [ interface {interface-type interface-number | interface-name } ] ] command to check information about the Eth-Trunk interface and its active member interfaces.
  • Run the display interface eth-trunk [ trunk-id ] command to check the Eth-Trunk interface status.
  • Run the display interface brief command to check brief information about the Eth-Trunk interface, including the physical status, link protocol status, and bandwidth usage.
  • Run the display trunkfwdtbl eth-trunk trunk-id [ slot slot-id ] command to check the forwarding table on the Eth-Trunk interface.

    The parameter slot slot-id in this command is supported only on the Admin-VS.

Parent Topic: Configuring an Eth-Trunk Interface to Work in Static LACP Mode
Copyright © Huawei Technologies Co., Ltd.
Copyright © Huawei Technologies Co., Ltd.
< Previous topic