Verifying the Configuration of the Eth-Trunk Interface in Manual Load Balancing Mode

After an Eth-Trunk interface in manual load balancing mode is successfully configured, verify the configuration, including the Eth-Trunk ID, working mode, and status of member interfaces.

Prerequisites

An Eth-Trunk interface in manual load balancing mode has been configured.

Procedure

Run the display trunkmembership eth-trunk trunk-id command to check information about member interfaces of the Eth-Trunk interface.
Run the display eth-trunk [ trunk-id [ interface interface-type interface-number interface-name | verbose ] ] command to check information about the Eth-Trunk interface and its active member interfaces.
Run the display interface eth-trunk [ trunk-id ] command to check the status of the Eth-Trunk interface.
Run the display interface brief command to check brief information about the Eth-Trunk interface, including the physical status, link protocol status, and bandwidth usage.
Run the display trunkfwdtbl eth-trunk trunk-id [ slot slot-id ] command to check the forwarding table on the Eth-Trunk interface.

The parameter slot slot-id in In VS mode, this command is supported only by the admin VS.