Verifying the HVPN Configuration

After you configure an HVPN, check on a local CE the default route or specific routes from this CE to a remote CE.

The HVPN has been configured.

Run the display ip routing-table command on a local CE to check routing table information.
- If you have configured an HoVPN, the command output shows a default route from the local CE to the remote CE. The next hop of the route is a UPE.
- If you have configured an H-VPN, the command output shows specific routes from the local CE to the remote CE.
Run the display mpls lsp protocol bgp [ nexthop nexthop-address ] [ lsr-role { egress | ingress | transit } ] [ verbose ] command to check information about the LSP established using BGP for BGP IPv4 VPN routes.