Configuring IGMP Dual-Device Hot Backup in a VRRP Active-Active Scenario (Binding a Multicast Service Interface to an mVRRP Group)

If a node or link fails on an IGMP dual-device hot backup network, a rapid multicast service switchover is triggered, improving service reliability. This section describes how to configure IGMP dual-device hot backup in a VRRP active-active scenario.

Prerequisites

A VRRP group has been configured using the vrrp vrid virtual-router-id [ virtual-ip virtual-address ] command, and the group has been configured as an mVRRP group using the admin-vrrp vrid virtual-router-id [ ignore-if-down ] command.

Context

In a VRRP active-active scenario, both the master and backup devices in a VRRP group can receive IGMP messages, but only the master device can send multicast traffic to downstream devices. Such implementation facilitates multicast service control and management and improves multicast service reliability.

To configure IGMP dual-device hot backup in a VRRP active-active scenario, perform the following steps on the devices in the same VRRP group.

Procedure

Configure an interface monitoring group and a BFD session.
1. Run system-view
  The system view is displayed.
2. Run monitor-group monitor-group-name
  An interface monitoring group is created, and the group view is displayed.
3. Run monitor enable
  The monitoring function is enabled for the interface monitoring group.
4. Run binding interface interface-name
  The interface to be monitored is added to the interface monitoring group.
5. Run quit
  Return to the system view.
6. Run bfd session-namebind peer-ip ip-address
  A BFD session is created to monitor a specified peer.
7. Run discriminator local discr-value
  A local discriminator is configured.
8. Run discriminator remote discr-value
  A remote discriminator is configured.
9. Run quit
  Return to the system view.
Configure rapid service link switching.
1. Run multicast routing-enable
  IP multicast routing is enabled.
2. Run interface interface-typeinterface-number
  The interface view is displayed.
3. Run pim sm
  PIM-SM is enabled on the interface.
4. Run igmp enable
  IGMP is enabled.
5. (Only on the interface that connects the backup device to the master device) Run vrrp vrid virtual-router-id trackbfd-session { bfd-session-id | session-name bfd-configure-name } [ increased value-increased | [ reduced priority-value ] ]
  The mVRRP group is enabled to track the BFD session.
6. (On the interface that connects the master and backup devices) Run vrrp vrid track monitor-group virtual-router-id track monitor-group [ monitor-group-name ] failure-ratio failure-ratio-value [ link | [ reduced priority-value ] ]
  The mVRRP group is enabled to track the interface monitoring group.
7. (On the interface that connects to a downstream device) Run multicast track admin-vrrp interface interface-typeinterface-number vrid vrid-value
  The multicast service interface is bound to the mVRRP group.
8. (On the interface that connects to a downstream device) Run pim ignore dr-state
  The interface is enabled to ignore the PIM DR state.
9. (On the interface that connects to a downstream device) Run pim ignore assert-state
  The interface is enabled to ignore the PIM Assert state.
10. (On the interface that connects to a downstream device) Run quit
  Return to the system view.
11. Run commit
  The configuration is committed.