After sampling packets, each NetStream-enabled interface board sends sampled packets to the NetStream service processing board for aggregation and output. If the NetEngine 8000 F has more than one NetStream service processing board, these NetStream services boards work in redundancy mode to back up each other and balance traffic, which improves system reliability.
Context
NetStream services can be processed in the following mode:
The ip netstream sampler to slot command has the same function as the ipv6 netstream sampler to slot command.
- The execution of either command takes effect on all packets, and there is no need to configure both of them. If it is required to configure both of them, ensure that NetStream service processing modes are the same. A mode inconsistency causes an error.
Procedure
- Configure the distributed NetStream service processing mode.
- Run system-view
The system view is displayed.
- Run slot slot-id
The view of the slot in which the interface board for NetStream sampling resides is displayed.
- Run ip netstream sampler to slot self
The distributed NetStream service processing mode is specified.
- Run commit
The configuration is committed.