By binding RIP and MIBs, you can view and configure RIP through the NMS.
Through Simple Network Management Protocol (SNMP), the RIP Management Information Base (MIB) manages multicast information exchanged between the NMS and agents.
Before controlling RIP configuration through an SNMP agent, complete the following tasks:
Configure IP addresses for interfaces to ensure that neighboring nodes are reachable at the network layer.
The system view is displayed.
The MIB is bound to the RIP process ID, and the ID of the RIP process that accepts SNMP requests is specified.
The configuration is committed.
Run the following commands to check the previous configuration.
Run the display current-configuration command to check the valid parameters on the device.