Verifying the Configuration of Applying Filters to the Imported Routes

After applying filters to the imported routes, verify information about the routing table of each protocol.

Filters have been applied to the imported routes.

Run the display rip process-id route command to check information about the RIP routing table.
Run the display ospf [ process-id ] routing command to check information about the OSPF routing table.
Run the display isis [ process-id ] route command to check information about the IS-IS routing table.
Run the display ip routing-table command to check information about the IP routing table.
Run the display ip routing-table command on the local router, and you can view that the routes that meet the matching rules set on the neighbor are filtered or the actions defined by apply clauses are performed on these routes.