Enabling MPLS on each node in an SR-MPLS domain is the prerequisites for configuring an SR-MPLS BE tunnel.
Procedure
- Run system-view
The system view is displayed.
- Run mpls lsr-id lsr-id
An LSR ID is set for the local node.
Note the following when configuring an LSR ID:
- LSR IDs must be set before other MPLS commands are run.
- By default, no LSR ID is set for an LSR, and an LSR ID can only be manually set.
- Using the IP address of a loopback interface as the LSR ID is recommended for an LSR.
- Run mpls
The MPLS view is displayed.
- Run commit
The configuration is committed.