Configuring BPDU Protection on a Device

After bridge protocol data unit (BPDU) protection is enabled on a device, the device shuts down an edge port if the edge port receives a BPDU, and notifies the NMS of the shutdown event.

Context

Edge ports are directly connected to user terminals and normally, the edge ports will not receive bridge protocol data units (BPDUs). Some attackers may send pseudo BPDUs to attach the device. If the edge ports receive the BPDUs, the device automatically configures the edge ports as non-edge ports and triggers new spanning tree calculation. Network flapping then occurs. BPDU protection can be used to protect devices against malicious attacks.

Do as follows on a device having an edge port:

Procedure

Run system-view
The system view is displayed.
Run stp bpdu-protection
BPDU protection is enabled on the device.
Run commit
The configuration is committed.

Follow-up Procedure

To allow an edge port to automatically start after being shut down, you can run the error-down auto-recovery cause cause-item interval interval-value command to configure the auto recovery function and set the delay on the port. After the delay expires, the port automatically goes Up. interval interval-value ranges from 30 to 86400, in seconds. Note the following when setting this parameter:

There is no default value for the recovery time. Therefore, you must specify a delay when configuring this command.
The smaller the interval-value is, the shorter it takes for the edge port to go Up, and the more frequently the edge port alternates between Up and Down.
The larger the interval-value is, the longer it takes for the edge port to go Up, and the longer the service interruption lasts.