Setting Priority Values for an MPLS TE Tunnel

Procedure

1. Run system-view

   The system view is displayed.

2. Run interface tunnel tunnel-number

   The view of the MPLS TE tunnel interface is displayed.

3. Run mpls te priority setup-priority [ hold-priority ]

   The priority values are set for the MPLS TE tunnel.

   Both the setup and holding priority values range from 0 to 7. The smaller the value, the higher the priority.

   

   The setup priority value must be greater than or equal to the holding priority value. This means the setup priority is lower than or equal to the holding priority.

4. Run commit

   The configuration is committed.