Configuring the Ingress of the Static CR-LSP

Procedure

1. Run system-view

   The system view is displayed.

2. Run static-cr-lsp ingress { tunnel-interface tunnel interface-number | tunnel-name } destination destination-address { nexthop next-hop-address | outgoing-interface interface-type interface-number } ^* out-label out-label [ bandwidth [ ct0 ] bandwidth ]

   The LSR is configured as the ingress of the specified static CR-LSP.

   To modify the destination destination-address, nexthop next-hop-address, outgoing-interface interface-type interface-number, or out-label out-label, run the static-cr-lsp ingress command to set a new value. There is no need to run the undo static-cr-lsp ingress command before changing a configured value.

   tunnel interface-number specifies the MPLS TE tunnel interface that uses this static CR-LSP. By default, the Bandwidth Constraints value is ct0, and the value of bandwidth is 0. The bandwidth used by the tunnel cannot be higher than the maximum reservable bandwidth of the link.

   The next hop or outgoing interface is determined by the route from the ingress to the egress. For the difference between the next hop and outbound interface, see "Static Route Configuration" in HUAWEI NetEngine 8000 F Series Router Configuration Guide - IP Routing.

   If an Ethernet interface is used as an outbound interface, the nexthop next-hop-address parameter must be configured.

3. Run commit

   The configurations are committed.