Configuring the Egress of the Static CR-LSP

This section describes how to configure the egress of a static CR-LSP. Before you set up a static CR-LSP, specify the egress of the CR-LSP.

Perform the following steps on the egress of the static CR-LSP:

Run system-view
The system view is displayed.
Run static-cr-lsp egress lsp-name incoming-interface interface-type interface-number in-label in-label [ lsrid ingress-lsr-id tunnel-id tunnel-id ]
The LSR is configured as the egress of the specified static CR-LSP.

To modify the incoming-interface interface-type interface-number or in-label in-label-value, run the static-cr-lsp egress command to set a new value. There is no need to run the undo static-cr-lsp egress command before changing a configured value.
Run commit
The configurations are committed.