Configuring Dynamic BFD for Initiated RSVP-TE Tunnel

RSVP-TE tunnels that a controller runs the PCE Initiated LSP protocol to establish can only be monitored by dynamic BFD.

Context

Configuring dynamic BFD to monitor RSVP-TE Initiated tunnels is recommended. If no BFD session is configured, the tunnel goes Up by default, but its actual status cannot be determined.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls

    The MPLS view is displayed.

  3. Run mpls te bfd tunnel enable auto-primary-tunnel pce-initiated-lsp

    Dynamic BFD for initiated RSVP-TE tunnel is enabled globally.

  4. Run commit

    The configuration is committed.

Parent Topic: Configuring an Automatic RSVP-TE Tunnel
Copyright © Huawei Technologies Co., Ltd.
Copyright © Huawei Technologies Co., Ltd.
< Previous topic Next topic >